FAQ: How To Install A Heating Element Assembly For A Sears He3 Elite Clothes Dryer?

Where is the heating element on a Kenmore front load dryer?

The heating element is located in the front section of the dryer on the bottom right. When you remove the lower front inspection panel you will see the heating element on the right hand side on the base of the dryer.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

Why is my Kenmore Elite dryer not drying my clothes?

If the vent is clogged or partially clogged, it will restrict the airflow through the dryer, substantially increasing the drying time. To ensure proper dryer performance, you should clean your dryer’s venting system at least once per year. If the air flow is weak, check the blower wheel for obstructions.

Why is my Kenmore Elite dryer not heating up?

The thermal fuse is a safety device designed to protect the dryer from overheating. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check the dryer venting when replacing a blown thermal fuse.

You might be interested:  Readers ask: How To Connect Wires Whirlpool Heating Element?

How dO I know if my thermal fuse is blown?

Touch the left multimeter lead to the left side of the thermal fuse; touch the right multimeter lead to the right side of the fuse. Keep an eye on the multimeter needle; a needle that fails to move indicates a blown thermal fuse.

What causes a heating element to burn out in a dryer?

A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.

Leave a Reply

Your email address will not be published. Required fields are marked *