FAQ: How To Replace A Heating Element On Kenmore Elite Steam Dryer Model 796.69272000?

Where is the heating element located on a Kenmore dryer?

The heating element is located in the front section of the dryer on the bottom right. When you remove the lower front inspection panel you will see the heating element on the right hand side on the base of the dryer.

Why is my Kenmore Elite dryer not heating up?

The thermal fuse is a safety device designed to protect the dryer from overheating. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check the dryer venting when replacing a blown thermal fuse.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

Is there a reset button on Kenmore dryer?

Is there a reset button on the machine? There is no reset button on your dryer. I recommend locating the two (2) house circuit breakers dedicated for the dryer and reset both circuit breakers by flipping them both OFF and ON 2-3 times and then check to see if the dryer will start.

You might be interested:  Often asked: How To Access The Heating Element In A Kenmore Dryer From The Front Panel?

How hard is it to replace a heating element in a dryer?

Fortunately, replacing a heating element isn’t a terribly difficult job. You can usually find a replacement heating element at a local hardware store or online by searching for your dryer model number. Once you have the part, unplug the dryer, remove the back panel, remove the connections and install the new one.

What causes a heating element to burn out in a dryer?

A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.

What is wrong with a dryer when there is no heat?

Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element. If you gather your tools and follow this guide, you may be able to solve basic dryer heating problems on your own.

How much does a heating element for a Kenmore dryer cost?

For a Kenmore brand dryer, the typical cost of the heating element can usually be found ranging from $20 to $43 whether it is available at a local store or buy online.

Leave a Reply

Your email address will not be published. Required fields are marked *