How To Get To Heating Element In 2010 Sundance Spa 6000 Series?

How do I check the heating element in my spa?

To test hot tub heating elements for integrity, use an ohm meter on its lowest setting. With the meter’s test leads, measure the resistance between the two element terminals. The acceptable resistance range for most heaters is between 9-12Ω (ohms), some may be as high as 20Ω.

How do you unlock the Sundance spa control panel?

Press DISPLAY, MODE and (down) button within 3 seconds to unlock panel.

Where is the heater located in a hot tub?

Take off the side panel or access panel. This is normally located where the main power supply is connected to the hot tub. Look for the metal tube or pipe this will be the heater. If in doubt and possible trace the pipe from the filter housing to the metal tube or pipe.

How much does a heating element cost for a hot tub?

How Much Does It Cost to Replace a Heater in a Hot Tub? Hot tub heater replacement cost ranges from $225 to $650, including $150 to $500 for the heating element. These last about 5 years before developing significant issues such as: Broken or burnt-looking spots.

You might be interested:  FAQ: What Number Do I Need To Type In Off My Dryer To Find A Heating Element Online?

Why is my hot tub not heating up?

Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes or blocked spa drain covers can also cause flow issues.

How do I know if my heating element is bad in my hot tub?

To test if a bad heater is causing your tripped breaker, you can disconnect the copper tabs (or wires) from the spa pack to the heater element. Once disconnected, turn the power back on. If the breaker stays on, you’ve determined that the heater is bad.

How do I know if my hot tub circuit board is bad?

You should see 220 volts. If you do not, then the circuit board is faulty and will need to be replaced or sent to us for repair. If you do see 220 volts and it is not heating then the heating element is defective and will need to be replaced.

What makes heating elements fail?

Among the conditions that can cause elevated temperatures are insufficient airflow in the element compartment, failure of safety devices and a power surge.

How do I reset my Sundance spa?

Solution: Try turning off the spa for 1-2 minutes, then reboot. This allows ample time for the board to get a full reboot. If problem persists move to next. Temperature overheat, a dirty filter or low flow conditions.

You might be interested:  Why Cant They Put The Heating Element From Back?

What does flo2 mean on a Sundance spa?

A flo2 error means that the board is reading a closed flow switch when there should not be any flow through the switch. Your first picture should be an open flow switch (reads no continuity), and the second would be it in the closed position (reads continuity).

Should I leave my hot tub heater on?

Depending on the amount you use your Lay‑Z‑Spa, in our experience it is better to leave the heater activated all of the time, if used regularly ‑ say 3 or more times per week. We would recommend setting the spa at 25°C to 35°C and then before using moving the temperature up to 40°C if desired.

How can I make my hot tub heat up faster?

You can heat a hot tub faster by turning on the jets, placing a cover over the tub, and using a more powerful heater. These are the easiest and most effective ways to increase your tub’s heating speed. It would be best if you didn’t fill a tub with hot water.

Leave a Reply

Your email address will not be published. Required fields are marked *