Often asked: How To Access The Heating Element In A Kenmore Dryer From The Front Panel?

How do you remove the front panel of a Kenmore front load dryer?

How to Open a Kenmore Dryer Panel

  1. Unplug your dryer from the electrical outlet.
  2. Open the lint trap cover if there is one and remove the lint trap.
  3. Grasp the top of the dryer firmly with one hand on either side and pull toward you sharply and then lift up slightly.
  4. Look at the back of the machine.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

What causes a heating element to burn out in a dryer?

A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.

You might be interested:  Can A Dryer Heating Element Stays On Even When Door Is Open?

How hard is it to replace a heating element in a dryer?

Fortunately, replacing a heating element isn’t a terribly difficult job. You can usually find a replacement heating element at a local hardware store or online by searching for your dryer model number. Once you have the part, unplug the dryer, remove the back panel, remove the connections and install the new one.

How much does it cost to replace a heating element in a dryer?

A new heating element is usually between $40 and $100. This part might cost as low as $30 and as high as $200 or more, depending on the type of dryer.

How do I open my dryer to clean it?

How to Open a Dryer Front for Lint Cleaning

  1. Unplug the dryer from the wall prior to servicing.
  2. Slide a putty knife under the front left and right sides of the control panel to release the spring clips.
  3. Remove the two screws at the rear of the top panel and then slide the top panel forward and lift if off of the dryer.

How do you test a dryer electronic control board?

How to test your dryer’s rotary switch:

  1. Unplug your dryer and remove the control console panel on the top of your dryer to locate the rotary switch.
  2. Set your multi-meter to the Rx1 setting and place the probes on the switch’s terminals.
  3. With the probes still touching the terminals, press in on and hold the switch.

Leave a Reply

Your email address will not be published. Required fields are marked *