Often asked: How To Replace Heating Element For Whirlpool Dryerwhere Can I Buy One?

Do all Whirlpool dryers have the same heating element?

Whirlpool electric dryer heating elements are located in different locations on the machine depending on the model of dryer that you own. For a large amount of electric Whirlpool dryers have the heating element is located in the back of the dryer.

How can you tell if a dryer heating element is bad?

Inspect the metal wire coil for any breaks in the wire. If the wire is solid and has no breaks in it, the heating element should be good. If the wire has a break in it, the heating element is defective.

What causes a heating element to burn out in a dryer?

A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.

You might be interested:  How Many Amps For 5kw Heating Element?

When should I replace the heating element in my dryer?

If your dryer takes longer than usual to dry your clothes, or the air in the dryer never heats, your heating element might be bad. You can test your heating element to determine whether you need to replace it. Unplug your dryer from the utility room wall outlet.

Where is the heating element located on my Whirlpool dryer?

Whirlpool usually locates the heating element on the back of dryer (must remove back of dryer) or under the drum (must remove front dryer). Be certain to disconnect power from dryer. Heating element coils look like stretched out door springs. A bad dryer heating element will have a break in the coil.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

How hard is it to replace a dryer heating element?

Fortunately, replacing a heating element isn’t a terribly difficult job. You can usually find a replacement heating element at a local hardware store or online by searching for your dryer model number. Once you have the part, unplug the dryer, remove the back panel, remove the connections and install the new one.

How many times can you replace a heating element in a dryer?

Bottom Line If the dryer is well-maintained and the vents and lint traps are kept clean, the heating element can last between 8 and 18 years. If the dryer is used on a daily basis and is not kept well-maintained, the heating element can burn out at any time.

You might be interested:  Question: Where Can I Buy Replacment Heating Element For Air Fryer?

How do you fix a dryer that is not heating?

This is the most common cause of a dryer not heating. To check if your venting is clogged, start a timed dry on high heat. Go to the exhaust vent outside and use your hand to verify that the air is very warm and exiting at a decent flow. If there’s little airflow, your venting likely needs to be cleaned or replaced.

How much does it cost to replace a heating element in a dryer?

A new heating element is usually between $40 and $100. This part might cost as low as $30 and as high as $200 or more, depending on the type of dryer.

How long does a heating element last in a dryer?

The heating element can last between 8 and 18 years if the dryer is well-maintained and the vent and lint traps are clean. The heating element can burn out if the dryer is not kept well-maintained.

Leave a Reply

Your email address will not be published. Required fields are marked *