- 1 Where is the heating element on my Whirlpool dryer?
- 2 How do you remove the heating coil on a Whirlpool Duet dryer?
- 3 How can you tell if a dryer heating element is bad?
- 4 Is it worth replacing a heating element in a dryer?
- 5 How hard is it to replace a dryer heating element?
- 6 What causes a heating element to burn out in a dryer?
- 7 How much does it cost to replace a heating element in a dryer?
- 8 How many times can you replace a heating element in a dryer?
- 9 Are dryer heating elements Universal?
Where is the heating element on my Whirlpool dryer?
Whirlpool usually locates the heating element on the back of dryer (must remove back of dryer) or under the drum (must remove front dryer). Be certain to disconnect power from dryer. Heating element coils look like stretched out door springs. A bad dryer heating element will have a break in the coil.
How do you remove the heating coil on a Whirlpool Duet dryer?
Unplug the power cord from the electrical outlet. Remove the screws holding the rear access panel in place. Remove the single screw at the top of the element assembly holding the heating element assembly in place. Pull the heating element assembly out of the dryer through the access panel.
How can you tell if a dryer heating element is bad?
Inspect the metal wire coil for any breaks in the wire. If the wire is solid and has no breaks in it, the heating element should be good. If the wire has a break in it, the heating element is defective.
Is it worth replacing a heating element in a dryer?
If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.
How hard is it to replace a dryer heating element?
Fortunately, replacing a heating element isn’t a terribly difficult job. You can usually find a replacement heating element at a local hardware store or online by searching for your dryer model number. Once you have the part, unplug the dryer, remove the back panel, remove the connections and install the new one.
What causes a heating element to burn out in a dryer?
A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.
How much does it cost to replace a heating element in a dryer?
A new heating element is usually between $40 and $100. This part might cost as low as $30 and as high as $200 or more, depending on the type of dryer.
How many times can you replace a heating element in a dryer?
Bottom Line If the dryer is well-maintained and the vents and lint traps are kept clean, the heating element can last between 8 and 18 years. If the dryer is used on a daily basis and is not kept well-maintained, the heating element can burn out at any time.
Are dryer heating elements Universal?
No, they are not interchangeable. If you do a google image search for “dryer heating element” you can easily see they come in a wide variety of shapes and sizes. One brand might use the same element for different models, but different brands are almost never interchangeable.