Quick Answer: How Replace Heating Element In Kenmore 402. 89032010?

Where is the heating element on a Kenmore front load dryer?

The heating element is located in the front section of the dryer on the bottom right. When you remove the lower front inspection panel you will see the heating element on the right hand side on the base of the dryer.

Why is my Kenmore Elite dryer not heating up?

The thermal fuse is a safety device designed to protect the dryer from overheating. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check the dryer venting when replacing a blown thermal fuse.

What causes a heating element to burn out in a dryer?

A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

You might be interested:  Where Can I Buy A Stove Heating Element?

How dO I know if my thermal fuse is blown?

Touch the left multimeter lead to the left side of the thermal fuse; touch the right multimeter lead to the right side of the fuse. Keep an eye on the multimeter needle; a needle that fails to move indicates a blown thermal fuse.

How do I know if my heating element is bad?

Touch a probe on the multitester to each screw on the element. If you get no reading, or a maximum reading, the element is bad. Elements do have some resistance, so a reading of 10-16 ohms is normal, with higher ohm readings for 3,500 watt elements and lower readings for 5,500 watt elements.

What is wrong with a dryer when there is no heat?

Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element. If you gather your tools and follow this guide, you may be able to solve basic dryer heating problems on your own.

Why is my Kenmore dryer blowing cold air?

With electrically heated dryers, the most common problems are a defective thermostat or an open heating element. In some cases, the high-limit thermostat is a thermal fuse; if this thermal fuse has burned open, the dryer blows cold air. Thermal fuses do not reset, and need to be replaced.

Do Kenmore dryers have a reset button?

Is there a reset button on the machine? There is no reset button on your dryer. I recommend locating the two (2) house circuit breakers dedicated for the dryer and reset both circuit breakers by flipping them both OFF and ON 2-3 times and then check to see if the dryer will start.

You might be interested:  FAQ: How To Replace Heating Element In Ovendryer?

Can a clogged dryer vent cause no heat?

Dryer vent is clogged This is the most common cause of a dryer not heating. To check if your venting is clogged, start a timed dry on high heat. Go to the exhaust vent outside and use your hand to verify that the air is very warm and exiting at a decent flow.

Leave a Reply

Your email address will not be published. Required fields are marked *