Quick Answer: How To Replace Heating Element In Kenmore Elite Front Load Dryer?

Where is the heating element on a Kenmore Elite front load dryer?

The heating element is located in the front section of the dryer on the bottom right. When you remove the lower front inspection panel you will see the heating element on the right hand side on the base of the dryer.

Why is my Kenmore Elite dryer not heating up?

The thermal fuse is a safety device designed to protect the dryer from overheating. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check the dryer venting when replacing a blown thermal fuse.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

Why is the dryer not heating up?

Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element. If you gather your tools and follow this guide, you may be able to solve basic dryer heating problems on your own.

You might be interested:  How To Change Electric Heating Element In Rv Water Heater.?

Do Kenmore dryers have a reset button?

Is there a reset button on the machine? There is no reset button on your dryer. I recommend locating the two (2) house circuit breakers dedicated for the dryer and reset both circuit breakers by flipping them both OFF and ON 2-3 times and then check to see if the dryer will start.

Can a clogged dryer vent cause no heat?

Dryer vent is clogged This is the most common cause of a dryer not heating. To check if your venting is clogged, start a timed dry on high heat. Go to the exhaust vent outside and use your hand to verify that the air is very warm and exiting at a decent flow.

Leave a Reply

Your email address will not be published. Required fields are marked *