Quick Answer: How To Replace Thermostats Or Heating Element In A Kenmore 700 Dryer?

Where is the heating element on a Kenmore 700 Series dryer?

The heating element is located in the front section of the dryer on the bottom right. When you remove the lower front inspection panel you will see the heating element on the right hand side on the base of the dryer.

Where is the thermostat located on a Kenmore dryer?

The operating thermostat for your dryer is on the blower housing. It is Key 42 in the first image below. To access this thermostat, unplug the dryer and pull off the back panel. To check it, remove the wires and measure the resistance across the leads of the thermostat with a volt/ohm meter.

Is it worth replacing a heating element in a dryer?

If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.

What causes a heating element to burn out in a dryer?

A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.

You might be interested:  Often asked: How To Change A Heating Element In An Electric Water Heater?

Will the dryer run if the thermal fuse is blown?

A gas dryer will run but won’t heat if its thermal fuse blows because the dryer overheated (usually because the vent is clogged, so check the vent path).

What causes a Kenmore dryer not to heat?

The heating element warms the air before it enters the dryer drum. Over time, the heating element can burn out, causing the dryer not to heat. The heating element assembly warms the air before it enters the dryer drum. Over time, the heating element can burn out, causing the dryer not to heat.

How can I test if my thermostat is working?

The most common signs of a broken thermostat are:

  1. Thermostat display is off or is non-responsive.
  2. Turning on the heat or AC does nothing.
  3. The heat or AC will come on, but either stays on nonstop or cuts out before the temperature setting is reached.

What happens if dryer thermostat is bad?

Bad Dryer Thermistor or Thermostat If the dryer does heat up, a bad dryer thermostat can result in loss of temperature control. If you have a faulty dryer thermostat, the dryer may keep the heat on for too long, causing the dryer to get too hot. If the cycling thermostat is defective, the dryer will not heat up.

Why would a dryer not heat up?

Is your dryer not heating up? Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element.

Leave a Reply

Your email address will not be published. Required fields are marked *