Readers ask: How To Remove The Heating Element On A Whirlpool Dryer?

Where is the heating element on a Whirlpool front load dryer?

The next appliance part to check is the heating element, because it is easy to prove if it is good or bad with a visual inspection. Whirlpool usually locates the heating element on the back of dryer (must remove back of dryer) or under the drum (must remove front dryer). Be certain to disconnect power from dryer.

How do you disconnect a heating element from a dryer?

Instructions

  1. Shut off the power. Unplug the dryer to disconnect electrical power.
  2. Remove the back panel.
  3. Disconnect the wires.
  4. Remove the heating element.
  5. Transfer the high-limit thermostat to the new heating element.
  6. Install the new heating element.
  7. Reattach the back panel.
  8. Plug in the dryer.

How can you tell if a dryer heating element is bad?

Inspect the metal wire coil for any breaks in the wire. If the wire is solid and has no breaks in it, the heating element should be good. If the wire has a break in it, the heating element is defective.

You might be interested:  Quick Answer: Heating Element For Oven Rests On The Bottom What Type Of Liner?

Is dryer heating element hard to replace?

Fortunately, replacing a heating element isn’t a terribly difficult job. You can usually find a replacement heating element at a local hardware store or online by searching for your dryer model number. Once you have the part, unplug the dryer, remove the back panel, remove the connections and install the new one.

How much does it cost to replace the heating element in a dryer?

A new heating element is usually between $40 and $100. This part might cost as low as $30 and as high as $200 or more, depending on the type of dryer.

Why is the dryer not heating up?

Common reasons for an electric or gas dryer not heating are a tripped circuit breaker, clogged vent, and no gas flow. Other potential reasons include a faulty thermal fuse and broken heating element. If you gather your tools and follow this guide, you may be able to solve basic dryer heating problems on your own.

How do you troubleshoot a Whirlpool Duet dryer?

How to Troubleshoot a Whirlpool Duet Electric Dryer

  1. Inspect household fuses or breakers.
  2. Close the dryer door firmly.
  3. Press and hold the “Start” button for five seconds.
  4. Check the display on the dryer for error codes.

How do I fix my Whirlpool Duet dryer that won’t heat?

The most common causes for a Whirlpool Duet dryer not heating are: Lint build up inside the machine or dryer venting – to prevent lint build up be sure to clean the lint out of your dryer at least once every two years and clean out your venting at least once a year.

You might be interested:  Readers ask: How To Test A Heating Element On Dryer?

How long should a dryer heating element last?

The heating element can last between 8 and 18 years if the dryer is well-maintained and the vent and lint traps are clean. The heating element can burn out if the dryer is not kept well-maintained.

When should I replace the heating element in my dryer?

If your dryer takes longer than usual to dry your clothes, or the air in the dryer never heats, your heating element might be bad. You can test your heating element to determine whether you need to replace it. Unplug your dryer from the utility room wall outlet.

Leave a Reply

Your email address will not be published. Required fields are marked *